Issue link: http://alpine.uberflip.com/i/577795
29 AutoMill HP ™ P R O D U C T M A N U A L EN NOTE If 1/16 inch was removed from the board the Lumber Stop is in calibration. It is not necessary to proceed with the following steps. Step 9. Click Calibration on the Main Menu Toolbar. Step 10. Click Lumber Stop on the Calibration Menu. Step 11. Jog the Lumber Stop left or right using the jog buttons as shown in Figure 46. Jog Left Jog Right Figure 47 Step 12. Click Calibrate on the Axis Calibration Screen Step 13. Perform Steps 1 to 8 using the same board with the OA Len 3 inches shorter. Step 14. Repeat Steps 1 to 13 until 1/16 inch is removed from the cut board. 4.4.4. Lumber Stop Calibration When the Lumber Stop is properly calibrated a 90 degree cut setup will remove 1/16 inch off the end of the board using Head 2 (Figure 45). Lumber Stop Head 2 Lumber Stop Figure 45 Step 1. Turn the Key Switch to SETUP. Step 2. Select SEMI on the Main Menu. Step 3. On the Board Select Menu setup 90-90 cut as shown in Figure 46. Figure 46 • Set Angle 1 and 2 to 90 • Set Height 1 to 0-3-8 • Set OA Len to 10-0-0 NOTE The remaining length values will calculate automatically. Step 4. Click SETUP on the Board Select Menu. Step 5. Click SETUP on the Run Menu. Step 6. Wait for the saw to move into position and turn the Key Switch to RUN. Step 7. Click AutoStart on the Run Menu. Step 8. Make a note of how much material was removed from the board.