Issue link: http://alpine.uberflip.com/i/577795
17 AutoMill HP ™ P R O D U C T M A N U A L EN 3.7. System Status Screen Click or touch Sys Status on the Main Menu (Figure 5) to open the System Status Screen (Figure 28). Figure 28 1. Board Stop Ext. – Command board stop to extend 2. Board Stop Ret. – Command board stop to retract 3. Exit – Close the System Status Screen and return to the Main Menu 4. Reset Fault – Clear all faults on the AutoMill HP The table below identifies each abbreviation used in Figure 28. FIXED END Abbreviation MOVEABLE END Abbreviation Angle 3 A3 Angle 1 A1 Angle 3 Up/Down A3 U/D Angle 1 Up/Down A1 U/D Angle 4 A4 Angle 2 A2 Angle 4 In/Out A4 I/O Angle 2 In/Out A2 I/O Angle 5 A5 Carriage (Length) LENGTH Angle 5 In/Out A5 I/O Lumber Stop LUM STOP Angle 5 Up/Down A5 U/D Right Material Conveyor Chain Drive RMCD Left Material Conveyor Chain Drive LMCD Right Material Conveyor In/Out RMC I/O Left Material Conveyor In/Out LMC I/O Right Hold-Down Chain Drive RHDD Left Hold-Down Chain Drive LHDD Right Hold-Down In/Out RHD I/O Left Hold-Down In/Out LHD I/O Right Hold-Down Up/Down RHD U/D Left Hold-Down Up/Down LHD U/D