Issue link: http://alpine.uberflip.com/i/577795
21 AutoMill HP ™ P R O D U C T M A N U A L EN 3. Jog Axis Up – Click the arrow to jog the axis up (performed at the default or set jog speed). 4. Jog Axis Down – Click the arrow to jog the axis down (performed at the default or set jog speed). 5. Jog Axis Up Fast – Click the arrow to jog the axis up (performed at full machine speed). 6. Jog Axis Down Fast – Click the arrow to jog the axis down (performed at full machine speed). 7. Move To – Click to open the Command Value Screen (Figure 34). 8. Calibrate – Click to calibrate the axis using the value entered on the Command Value Screen (Figure 34) 9. Saw Motors – Click to open the Saw Motor Dialogue Box (Figure 31). 10. EXIT – Click to exit and return to the Main Menu (Figure 5). 4.2.1. Command Value Screen Figure 34 1. Current Axis Value – Displays the calibration point value (Figure 34). 2. Commanded Value – Click to box to enter the new calibration value using the keypad (Figure 34). 3. START MOVE – Click to move axis from current position to new calibration value. 4. DONE – Click to return to the Axis Calibration Screen (Figure 34). 4.2. Manual Axis Calibration (Overview) This section provides a general overview of the manual calibration process. The principals introduced in this section apply to each calibration process (Angles, I/O, and Carriage). Any process differences or deviations will be noted in the corresponding section. Selecting an axis on the Calibration Menu (Figure 30) will open the Axis Calibration Screen (Figure 33). Figure 33 The Axis Calibration Screen (Figure 33) will have the same buttons for each axis. However, they may be arranged differently depending on the direction the axis moves during the calibration process. Axis Name – Displays the axis selected on the Calibration Menu (Figure 30) or from the drop down menu. Value – Displays the current calibration value for the selected axis. Status – • Red – Axis not homed/not ready for calibration (if the status bar is red click Home Axis • Green – Axis properly homed/ready for calibration Calibration Point – Displays the calibration point for the selected axis. This number is used as a basis to bring the saw into calibration. Limits – Displays the Upper and Lower movement constraints for the selected axis. 1. Set Job Speed – Opens a slider bar to adjust the axis jog speed. Once the slider is closed the jog speed will return to its default value. 2. Drop down menu – Click the arrow to change the selected axis without leaving the Axis Calibration Screen.