Issue link: http://alpine.uberflip.com/i/577795
11 AutoMill HP ™ P R O D U C T M A N U A L EN 3.2. AUTO Mode Turn the Mode Switch on the Operator Console (Figure 4) to SETUP. ! CAUTION Confirm that the security bypass and length bypass switches are in the OFF position. The saw can crash if these safety features are disabled. Click or touch AUTO on the Main Menu to advance to the Job Select Menu (Figure 5). 3.2.1. Job Select Menu Figure 6 The Job Select Menu (Figure 6) displays all the information about the job as contained in the TRS file. 1. Indicates all the available TRS files within the Jobs file on the AutoMill HP computer 2. Displays the following information: • TOTAL SETUPS – The total number of unique pieces in the job. • TOTAL PIECES – The TOTAL SETUPS times the quantity for each. 3. New Job – Allows the use to search for a TRS file by name on the saw computer (Figure 6, 7, 8). Figure 7 Figure 8 4. CHANGE JOB LOCATION – Allows user input to specify the computer path to the location where the jobs are stored. This path can be any location that is accessible from the saw computer. The hard drive of the computer, USB, or a network drive can be the source of the job location (Figure 8). 5. UTILITY – Allows user to modify the TRS file (Section 3.4) 6. Piece Select Menu – Indicates all pieces within the selected TRS file. RED indicates the piece has been cut. 7. PREV – Returns the piece panel one page. 8. NEXT – Advances the piece panel one page. 9. CANCEL – Cancels the current operation and returns the software to the Main Menu. 10. SETUP – Advances the software to the Run Menu (Figure 9) using the selected TRS file.