Issue link: http://alpine.uberflip.com/i/577795
26 AutoMill HP ™ P R O D U C T M A N U A L EN Step 16. Click Calibrate, the position value will be set to 0.00 inches automatically. NOTE Head 4 I/O is now calibrated; continue with the steps to calibrate Head 5 I/O. Step 17. Return to the SEMI screen and setup the same cut as described in Step 3. Step 18. Click SETUP on the Board Select Menu. Step 19. Click SETUP on the Run Menu. Step 20. Wait for the saw to move into position and turn the Key Switch to RUN. Step 21. On the Run Menu, slow down the material conveyor speed to 5, Section 3.2.2 shows the location of the button required to slow the conveyor. Step 22. Click AutoStart and feed the board into the saw. Step 23. Once the board has passed Head 4, turn the Key Switch to SETUP to stop it in front of the Head 5 Blade (refer to Figure 37). Step 24. Click Calibration on the Main Menu Toolbar. Step 25. On the Calibration Menu, click Head 5 Lt./ Rt. Step 26. Click Select Jog Speed to open the jog speed slider bar Step 27. Click and hold the slider bar, moving it left until the jog speed is reduced to 2%. NOTE The jog speed reduction only affects the standard jog buttons. Step 28. Jog Head 5 left until the cutting edge (carbide teeth) touch the edge of the piece of lumber. Step 29. Click calibrate, the position value will be set to 0.00 inches automatically. Step 30. Turn the Security Bypass OFF NOTE Head 5 I/O is now calibrated. Step 7. On the Run Menu, slow down the material conveyor speed to 5, Section 3.2.2 shows the location of the button required to slow the conveyor. Step 8. Click AutoStart and feed the board into the saw. Step 9. Once the board has passed Head 3, turn the Key Switch to SETUP to stop it in front of the Head 4 Blade (Figure 40). Head 5 Head 4 Lumber Head 3 Figure 40 Step 10. Turn Security Bypass ON (Section 2.3) ! WARNING When the Security Bypass is ON the anti-crash system is disabled. It is possible to crash moving components of the saw. It is essential to have the Security Bypass ON for I/O calibration. Call Alpine Technical Support with any questions. Step 11. Click Calibration on the Main Menu Toolbar. Step 12. On the Calibration Menu, click Head 4 Lt./ Rt. Step 13. Click Select Jog Speed to open the jog speed slider bar Step 14. Click and hold the slider bar, moving it left until the jog speed is reduced to 2%. NOTE The jog speed reduction only effects the standard jog buttons. Step 15. Jog Head 4 left until the cutting edge (carbide teeth) touch the edge of the piece of lumber.