Issue link: http://alpine.uberflip.com/i/577795
9 AutoMill HP ™ P R O D U C T M A N U A L EN 2.2. Safety Features ! WARNING To not remove or disable any of the safety features on the AutoMill HP. 2.3. Operator Console Major functions of the machine are controlled from the keyboard, mouse, and flat panel or touch-screen monitor (optional) in the Operator's Console. Figure 4 USB Port E-Stop Button Power ON Button Length Bypass OFF/ON Security Bypass OFF/ON Key Switch OFF/ON Mode Switch SETUP/RUN/AS E-Stop Button – Located on the Operator Console, pressing the button will immediately cut power to the blades and apply the air brakes. To reset the E-Stop Button, turn the button clockwise. Perimeter E-Stop Cable – Extended around the saw, pulling the cable in any direction will immediately cut power to the blades and apply the air brakes. To reset the E-Stop Cable, press the "R" Button (Figure 67). Metal Mesh Guards – Located on the infeed and outfeed ends of the saw, they create a barrier between the operator and moving components. Personnel Barrier – Located on the infeed of the saw, this safety feature is designed to keep the operator a safe distance from the automated components of the AutoMill HP. Air Disc Brakes – Located on each saw blade, this safety feature will stop the moving saw blades within seven seconds. Low Air Sensor – Located within the pneumatic system of the AutoMill HP, this safety feature will disable operation if the 80-90 psi requirement is not met.