Issue link: http://alpine.uberflip.com/i/577795
32 AutoMill HP ™ P R O D U C T M A N U A L EN Head 3 Carpenter's Square Right Material Conveyor Figure 53 Step 11. Click Calibrate on the Axis Calibration Screen. Step 12. Return to the Calibration Menu. Step 13. Click Left MC Lt. Rt. on the Calibration Menu. Step 14. Slowly jog the left material conveyor until it is 2 inches away from the Head 2 Blade. Use a carpenter's square to verify the measurement (Figure 53). ! CAUTION Do not use the Fast Jog button. Step 15. Click Calibrate on the Axis Calibration Screen. Step 16. Turn the Security Bypass OFF. 4.4.7. Material Conveyor Calibration Step 1. Check that the Hold-downs are level (Section 5.4). ! CAUTION If it is determined that the Hold-downs are not level follow the procedure in Section 5.4. Contact Alpine Technical Support with any questions. If the Hold-down is level proceed with the following steps to complete the calibration process. Step 2. Turn the Key Switch to SETUP (Section 2.3). Step 3. Select SEMI on the Main Menu. Step 4. On the Board Select Menu setup a cut as shown in Figure 52. Figure 52 • Set Angle 1 and 2 to 90 • Set Height 1 to 0-3-8 • Set OA Len to 4-0-0 NOTE The remaining length values will calculate automatically. Step 5. Click SETUP on the Board Select Menu. Step 6. Click SETUP on the Run Menu. Step 7. Click Calibration on the Main Menu Toolbar. Step 8. Turn the Security Bypass ON. Step 9. Click Right MC Lt. Rt. on the Calibration Menu. Step 10. Slowly jog the right material conveyor until it is 2 inches away from the Head 3 Blade. Use a carpenter's square to verify the measurement (Figure 53). ! CAUTION Do not use the Fast Jog button.