Issue link: http://alpine.uberflip.com/i/577795
20 AutoMill HP ™ P R O D U C T M A N U A L EN 4.1.2. Conveyor Control Panel Figure 32 1. LEFT MC DRIVE FWD – Click to jog the left material conveyor forward. 2. LEFT HD DRIVE FWD – Click to jog the left hold- down forward. 3. LEFT MC DRIVE REV – Click to jog the left material conveyor in reverse. 4. LEFT HD DRIVE REV – Click to jog the left hold down in reverse. 5. RIGHT MC DRIVE FWD – Click to jog the right material conveyor forward. 6. RIGHT HD DRIVE FWD – Click to jog the right hold- down forward. 7. RIGHT MC DRIVE REV – Click to jog the right material conveyor in reverse. 8. RIGHT HD DRIVE REV – Click to jog the right hold- down in reverse. 9. JOG SPEED – Click to select the jog speed (1-24; the default is 16) Along with the tiles, there are several other buttons on this screen: 1. HOME SYSTEM – Click this button to run the Homing procedure. 2. HOME CONVEYOR – Click this button to move and time the material conveyor dogs. 3. Unload Cal – Click this button to return to the previous screen. 4. GOTO Calibration Points – Click to move Heads to their current set calibration positions. 5. CONVEYOR – Click to open the conveyor control panel (Section 4.1.2). 6. Alpine Tech Support Buttons – Disable SW Limit, Enable AMP and Load Axis Limit are to only be used by Alpine Technical Support. 7. SAW MOTORS – Click this button to open the saw motor dialogue box (Figure 31). NOTE The homing procedure must be completed before calibration can begin. If the saw has not been homed, click HOME SYSTEM. 4.1.1. Saw Motor Dialogue Box Figure 31 Click SAW MOTORS on Figure 30 to open the saw motor dialogue box. Click HEAD 1-5 to manually start a saw blade motor. Click CONV. FWD or CONC. REV to manually start the material conveyor in the forward or reverse direction.