Issue link: http://alpine.uberflip.com/i/1399321
18 ALS 4.0 XE P R O D U C T M A N U A L EN 3.4.1 Board Select Click or touch SEMIMODE on the main menu to advance to the Board Select Menu. 1. Configuration Buttons – Click or touch the figure that is closest to the desired cut. The panel on the left "L" controls the left side of the board. The panel on the right "R" controls the right side of the board. 2. Angle Buttons – Click or touch the angle buttons to open the Angle Input Dialog Box. Angles 1 and 2 are shown on the left side of the board. Angles 3 and 4 are shown on the right side of the board Figure 22 3. Height Buttons – Click or touch the height buttons to open the Height Input Dialog Box. Height 1 is the overall height of the lumber. Heights 2 and 3 correspond to the pivot axis heights. 4. Length Buttons – Click or touch the length buttons to change the various lengths. • OA Len – Overall board length • Center Len – Centerline length • Top Len – Top length • Bot Len – Bottom length • PAL – Pivot axis length Figure 23 The SIZE and GRADE buttons will bring up screens when clicked. Here, the appropriate entries can be chosen. Within this dialogue box the following can be changed: • SPEED – Allows the system speed to be adjusted per stock entry. It is percentage based with 100% being full speed. • CHECK ALL – Selects all with a single selection • CLEAR ALL – Deselects all with a single selection • EXIT – Exits the dialog COST can be entered allowing the saw to calculate the lumber cost per the job pick list. Cost is based on board feet. The cost information must be manually entered and updated. The SAVE button will save all progress. 3.4 Semi-Automatic Operation Figure 20 Enter the Semi-Automatic Mode by clicking or touching the button shown in Figure 20 on the Main Screen. The following screen will appear (Figure 21): Figure 21 The default piece for this screen has square cuts on each end. Choose the ends that most closely match the piece required. In the example above, the single cut button has been selected for the left end and the single cut for the right end. The selections can be changed at any time as cuts are setup in this mode.