Issue link: http://alpine.uberflip.com/i/1399321
23 ALS 4.0 XE P R O D U C T M A N U A L EN Figure 29 3.6.3 Pick List Options (3) Turns on the Pick List Option 3.6.4 Cutting Options (4) 3.6.5 Saw-Production Reporter Options (5) 3.6.6 Standard Piece List (6) This button will give you access to the Standard Piece List. You will see it on Options. It will bring up a screen containing the Standard Piece List and cutting options. We will look: Figure 30 There are seven pieces in the list shown here. You can enter a maximum of 12. These particular pieces are end blocks (EB), ribbon blocks (RB), and diagonal webs (Diag) for 14 and 16-inch-deep Modified Warren floor trusses. Remember, these pieces can be anything. They don't all have to be square ended pieces as shown on this list. DELETE will remove the piece from the list. MODIFY will allow you to change the quantity only. The column of numbers to the right is the priority for each piece and the green and red flags control whether a piece will be cut or not. Proper use of these two columns is discussed later under Dead Reckoning Inventory System. Cut Standard Pieces – Turns the Standard Piece cutting option on or off. When off, no Standard Pieces will be cut. Mark Found Pcs Cut – When you open a job and Standard Pieces is on, the program searches through the job for any pieces that match those in your Standard Piece List. When it finds them, it marks them cut. This is very important. When the Standard Piece process is functioning properly, you should already have a supply of these pieces that have been previously cut and stored. You don't want to cut them again with the job. If you did, you would never use the pieces you had stored. Mark Found Pcs Cut should always be on when Standard Pieces is on. Standard Piece Max Waste – All waste lengths shorter than this entry will be cut into Standard Pieces. This will allow you to save long waste pieces (normally found at the end of a job) for purposes other than Standard Pieces. Path to Standard Pieces – This is reference information only. The location for the StdPcs.trs file cannot be changed. NOTE When you need to review the Standard Pieces List, use this button only.