Issue link: http://alpine.uberflip.com/i/1399321
11 ALS 4.0 XE P R O D U C T M A N U A L EN 1. AUTOMODE – Automatic saw operation mode. Data is read from the saw computer, USB drive, or network location (Section 4.2.1). 2. SEMIMODE – Semi-automatic saw operation mode. Allows operator entry for cutting data (Section 4.3). 3. System Status – Shows the current state of the machine 4. E-Stop – Indicates if the E-Stop Button is activated. 5. Language – Indicates the current language in use. Trilingual – English,French and Spanish. 6. Communication – Opens the team Viewer pop up window to connect remote users for troubleshooting. 7. System troubleshooting – Opens the Schneider Control System Status Screen. 8. Utility Tools – Opens the Manual Screen menu (Section 3.2) 9. Options – Opens the Options Menu (Section 3.3). 10. Auto-Infeed – Opens Auto-Infeed Timer Menu (Section 3.4) 11. Exit – Closed/Shutdown the ALS 4.0 program. NOTE It is strongly advised to cancel out of all active screens and back to the Main screen before quitting as there are times when this procedure will save valuable in-process information. It is also recommended that the saw computer have internet access. This will allow for remote access by Alpine for troubleshooting and diagnostic evaluation. 2.6.3 USB Device Sometimes called "jump drives" or "thumb drives", these devices are necessary if the saw is not connected to a network. The ALS 4.0 has a dustproof USB port mounted on the front panel of the operator's console for these devices, or any other USB device. The ALS 4.0 program communicates with these devices in the same manner as it would to a hard drive or network connection. 3. ALS 4.0 Software 3.1 ALS 4.0 Home Screen Figure 7 The top bar of the screen is present during most operations of the program. It allows navigation to other parts of the program without closing the screen being used. QUIT can be selected from any screen where the top bar is showing.