Issue link: http://alpine.uberflip.com/i/1399321
15 ALS 4.0 XE P R O D U C T M A N U A L EN 2. OK – This button is used only during Office Mode operation of the program. It switches the program to the Cut Screen simulating detection of a board. When running a single stock length, the OK button will be visible but once the cut is completed the screen will return to the Cut Screen automatically. NOTE OK is only visible if a single stock length is being run. Figure 14 3. CANCEL – This button can be used to return to the Job/Piece Select Screen. All cut status information for all previous cuts will be saved. This information can be reviewed on the Job/Piece Select Screen. If no changes are made to the cut status information or stock length click or touch cancel CANCEL. Then, RUN ALL can be used to maintain the Next Cut Order as set previously. 4. OK – This button is used only during Office Mode operation of the program. It switches the program to the Cut Screen simulating detection of a board. 3.3 Automatic Screen Operations 3.3.1 Load Lumber Screen Figure 13 This screen displays what size and grade of stock lumber to feed into the saw. 1. NEXT CUT ORDER – Displays a preview of the next board to be cut The gray bar near the bottom of the screen show how the computer has placed pieces on the stock. The gray bar shows the stock board that is set up, ready and will be cut next. The red and yellow colors of the pieces are alternated so that it noticeable where each board begins and ends. There is no other significance to these two colors. NOTE When the stock is changed, the Next Cut Order will be recalculated and the new piece layout will be shown. Occasionally, this recalculation will cause the Previous Cut Order layout to go off scale, but that will have no effect on upcoming cuts. It is not possible to make changes to the stocks if a picklist has been created for the job. When there are pieces on the stock that have beveled ends, the beveled edges will be green for double bevel, blue for single bevel front, or fuchsia for single bevel back. • The information shown on the first line on each piece is truss name. • The second line shows the piece name. • The third line shows the index of the piece and the piece length. The index number is assigned by the saw computer when the job is loaded. It corresponds to the position of the piece in the list on the Piece Select screen. It is not the quantity of the piece. It is shown on this screen for reference. It can be used when it is necessary to o find the piece in the job list on the Piece Select Screen (Figure 8).