Alpine Equipment Manuals

17 SpeedSet P R O D U C T M A N U A L EN Table 8 Truss Setup Screen Description Title (Refer to Figure 7) Picture Description 18. Default Position Reset truss position to default location. 19. Angle Rotated Adjusts the angle of truss rotation by degree. 20. L/R Flip Click to flip the truss right/left. 21. Camber Adjustment Adjusts the pucks to create a slight upward bow in the truss. 22. Done Press when all adjustments are complete to put the truss on the table.

• M1030-R2_Alpine-SpeedSet-EN
• 1.Introduction
• 1.1.Parts List
• 1.2.General Specifications
• 2.Getting to Know the SpeedSet
• 2.1.System Overview
• 2.2.Power Distribution
• 2.3.Motion Control Equipment
• 2.4.Tables and Liftouts
• 2.5.Getting Data to the SpeedSet
• 2.5.1. General
• 2.5.2.Network
• 2.5.3.USB Drive
• 3. SpeedSet Software
• 3.1.Assembly Tab 
• 3.2.Job Selection – Work List
• 3.3.Truss Setup Screen
• 3.4.Moving Pucks
• 3.5.Move Individual Puck
• 3.6.Repair Tab 
• 3.6.1. Homing Area
• 3.6.2. Individual Control
• 3.7.Check Tab 
• 4.Operation
• 4.1.Setup
• 4.2.Optional Liftout Operation
• 5.Table Homing
• 5.1.Background
• 5.2.Homing Procedure
• 6.Maintenance
• 6.1.Chain Tensioning
• 6.2.Daily / 8 Hours Maintenance
• 6.3.Weekly / 40 Hours Maintenance
• 6.4.Quarterly / 480 Hours Maintenance
• 7.Troubleshooting
• 7.1.Check Tab Error – Many "Ethernet Disconnected"
• 7.2.Check Tab Error – Single "Ethernet Disconnected"
• 7.3.Check Tab Error "Encoder Unplugged"
• 7.4.Check Tab Error Gateway Offline
• 7.5.Puck Won't Move (end of table)
• 7.6.Puck Won't Move (not on end stop) Motor not humming.
• 7.7.Puck Won't Move (not on end stop) Motor humming.
• 7.8.Puck Out of Position (small amounts)
• Appendix A – Computer System
• Appendix B – Maintenance Intervals
• Appendix C – Warranty
• M1030-R2_Alpine-SpeedSet-ES
• M1030-R2_Alpine-SpeedSet-FR