Alpine Equipment Manuals

EN SpeedSet Product Manual IMPORTANT! DO NOT DESTROY! It is the customer's responsibility to have employees read and understand this manual. Read instructions completely before using the equipment. Alpine SpeedSet Automated jigging system improves truss assembly efficiency through rapid computer-controlled setup and state-of-the-art software features

• M1030-R2_Alpine-SpeedSet-EN
• 1.Introduction
• 1.1.Parts List
• 1.2.General Specifications
• 2.Getting to Know the SpeedSet
• 2.1.System Overview
• 2.2.Power Distribution
• 2.3.Motion Control Equipment
• 2.4.Tables and Liftouts
• 2.5.Getting Data to the SpeedSet
• 2.5.1. General
• 2.5.2.Network
• 2.5.3.USB Drive
• 3. SpeedSet Software
• 3.1.Assembly Tab 
• 3.2.Job Selection – Work List
• 3.3.Truss Setup Screen
• 3.4.Moving Pucks
• 3.5.Move Individual Puck
• 3.6.Repair Tab 
• 3.6.1. Homing Area
• 3.6.2. Individual Control
• 3.7.Check Tab 
• 4.Operation
• 4.1.Setup
• 4.2.Optional Liftout Operation
• 5.Table Homing
• 5.1.Background
• 5.2.Homing Procedure
• 6.Maintenance
• 6.1.Chain Tensioning
• 6.2.Daily / 8 Hours Maintenance
• 6.3.Weekly / 40 Hours Maintenance
• 6.4.Quarterly / 480 Hours Maintenance
• 7.Troubleshooting
• 7.1.Check Tab Error – Many "Ethernet Disconnected"
• 7.2.Check Tab Error – Single "Ethernet Disconnected"
• 7.3.Check Tab Error "Encoder Unplugged"
• 7.4.Check Tab Error Gateway Offline
• 7.5.Puck Won't Move (end of table)
• 7.6.Puck Won't Move (not on end stop) Motor not humming.
• 7.7.Puck Won't Move (not on end stop) Motor humming.
• 7.8.Puck Out of Position (small amounts)
• Appendix A – Computer System
• Appendix B – Maintenance Intervals
• Appendix C – Warranty
• M1030-R2_Alpine-SpeedSet-ES
• M1030-R2_Alpine-SpeedSet-FR