Issue link: http://alpine.uberflip.com/i/711591
15 SpeedSet P R O D U C T M A N U A L EN 3.3. Truss Setup Screen Truss Adjustment This window is where trusses are placed on the table based on a snap point. From this screen, the truss can be rotated, flipped or moved around the table. Figure 7 Truss Setup Screen The "Truss Adjustment" screen is where the truss can be adjusted to different snap points and different truss points. Also the X and Y offset can be set for where the truss is based on the snap point. For example, you want to move the truss up 1ft. choose Y Offset and add set 1-0-0 or -1-0-0 for down 1ft. When "Done" is pressed, it will load it onto the table in the new location. Table 8 Truss Setup Screen Description Title (Refer to Figure 7) Picture Description 1. Coordinate Marker This show the direction of the table's coordinate system. 2. Snap Point This is one of the default starting locations the builds begin at. Click to move truss to this location. 3. Truss Drawing showing the truss location on the table. 4. Previous Point Move truss to the previous snap point.