Alpine Equipment Manuals

9 SpeedSet P R O D U C T M A N U A L EN Figure 3 Motion Control Equipment Table 5 Motion Control Equipment Number (Refer to Figure 3) Item Description 1 Ethernet Switch 8 Port 24V Ethernet switch 2 Controller VC1 Ethernet motion controller 3 Circuit Breaker 240VAC 2P 8A 4 Power Supply 24VDC 1A Class 2 5 VFD WEG 0.5HP variable speed drive 6 Wire Entry Wire entry strain relief 2.3. Motion Control Equipment

• M1030-R2_Alpine-SpeedSet-EN
• 1.Introduction
• 1.1.Parts List
• 1.2.General Specifications
• 2.Getting to Know the SpeedSet
• 2.1.System Overview
• 2.2.Power Distribution
• 2.3.Motion Control Equipment
• 2.4.Tables and Liftouts
• 2.5.Getting Data to the SpeedSet
• 2.5.1. General
• 2.5.2.Network
• 2.5.3.USB Drive
• 3. SpeedSet Software
• 3.1.Assembly Tab 
• 3.2.Job Selection – Work List
• 3.3.Truss Setup Screen
• 3.4.Moving Pucks
• 3.5.Move Individual Puck
• 3.6.Repair Tab 
• 3.6.1. Homing Area
• 3.6.2. Individual Control
• 3.7.Check Tab 
• 4.Operation
• 4.1.Setup
• 4.2.Optional Liftout Operation
• 5.Table Homing
• 5.1.Background
• 5.2.Homing Procedure
• 6.Maintenance
• 6.1.Chain Tensioning
• 6.2.Daily / 8 Hours Maintenance
• 6.3.Weekly / 40 Hours Maintenance
• 6.4.Quarterly / 480 Hours Maintenance
• 7.Troubleshooting
• 7.1.Check Tab Error – Many "Ethernet Disconnected"
• 7.2.Check Tab Error – Single "Ethernet Disconnected"
• 7.3.Check Tab Error "Encoder Unplugged"
• 7.4.Check Tab Error Gateway Offline
• 7.5.Puck Won't Move (end of table)
• 7.6.Puck Won't Move (not on end stop) Motor not humming.
• 7.7.Puck Won't Move (not on end stop) Motor humming.
• 7.8.Puck Out of Position (small amounts)
• Appendix A – Computer System
• Appendix B – Maintenance Intervals
• Appendix C – Warranty
• M1030-R2_Alpine-SpeedSet-ES
• M1030-R2_Alpine-SpeedSet-FR