Alpine Equipment Manuals

22 SpeedSet P R O D U C T M A N U A L EN Table 11 Homing Screen Description Title (Refer to Figure 11) Picture Description 1. Puck Puck number. 2. Progress Progress bar for each puck. 3. Cancel / Retry Click to cancel homing for this puck. Click retry if pucks stalls to home again. 4. Status Status and error messages appear here. 5. Special Calibration Adjustment 6. Cancel Homing Figure 11 Homing Screen 3.6.1. Homing Area These controls are used to home the pucks. After pressing the "Home" button, this list will show the progress of each puck and any errors that occur during the homing process.

• M1030-R2_Alpine-SpeedSet-EN
• 1.Introduction
• 1.1.Parts List
• 1.2.General Specifications
• 2.Getting to Know the SpeedSet
• 2.1.System Overview
• 2.2.Power Distribution
• 2.3.Motion Control Equipment
• 2.4.Tables and Liftouts
• 2.5.Getting Data to the SpeedSet
• 2.5.1. General
• 2.5.2.Network
• 2.5.3.USB Drive
• 3. SpeedSet Software
• 3.1.Assembly Tab 
• 3.2.Job Selection – Work List
• 3.3.Truss Setup Screen
• 3.4.Moving Pucks
• 3.5.Move Individual Puck
• 3.6.Repair Tab 
• 3.6.1. Homing Area
• 3.6.2. Individual Control
• 3.7.Check Tab 
• 4.Operation
• 4.1.Setup
• 4.2.Optional Liftout Operation
• 5.Table Homing
• 5.1.Background
• 5.2.Homing Procedure
• 6.Maintenance
• 6.1.Chain Tensioning
• 6.2.Daily / 8 Hours Maintenance
• 6.3.Weekly / 40 Hours Maintenance
• 6.4.Quarterly / 480 Hours Maintenance
• 7.Troubleshooting
• 7.1.Check Tab Error – Many "Ethernet Disconnected"
• 7.2.Check Tab Error – Single "Ethernet Disconnected"
• 7.3.Check Tab Error "Encoder Unplugged"
• 7.4.Check Tab Error Gateway Offline
• 7.5.Puck Won't Move (end of table)
• 7.6.Puck Won't Move (not on end stop) Motor not humming.
• 7.7.Puck Won't Move (not on end stop) Motor humming.
• 7.8.Puck Out of Position (small amounts)
• Appendix A – Computer System
• Appendix B – Maintenance Intervals
• Appendix C – Warranty
• M1030-R2_Alpine-SpeedSet-ES
• M1030-R2_Alpine-SpeedSet-FR