Issue link: http://alpine.uberflip.com/i/711591
16 SpeedSet P R O D U C T M A N U A L EN Table 8 Truss Setup Screen Description Title (Refer to Figure 7) Picture Description 5. Next Point Move truss to the next snap point. 6. Previous Truss Point Click to cycle to the previous truss alignment point. (Right Heel, Left Heel, Span Center) 7. Next Truss Point Click to cycle to the next truss alignment point. (Right Heel, Left Heel, Span Center) 8. Previous Truss Click to move to previous truss in the batch. 9. Next Truss Click to move to next truss in the batch. 10. Special Rotation Click to enable snap to board rotation. After selecting button, click on chord to rotate truss flat on table. Click again when selection is made. 11. Next Batch Move to next batch. 12. Previous Batch Move to previous batch. 13. Remove Truss Remove truss from table. 14. X Position Click to shift the truss left/right by a specific amount. 15. Move Left Click to move the truss left by the puck spacing distance. 16. Move Right Click to move the truss right by the puck spacing distance. 17. Y Position Click to shift the truss up/down by a specific amount.