Issue link: http://alpine.uberflip.com/i/985331
2 AutoMill SC Motion Control Upgrade P R O D U C T M A N U A L EN ! WARNING Read the following warnings before using this equipment. Read the following safety information before using this equipment: In this installation guide, the words WARNING, CAUTION, NOTICE and NOTE are used to emphasize important safety information as follows: ! CAUTION Indicates a hazardous situation which, if not avoided, will result in minor or moderate injury. ! WARNING Indicates a hazardous situation which, if not avoided, will result in death or serious injury. NOTE Important installation, operation or maintenance information. NOTICE Addressees important practices, failure to follow the instruction may result in damage to the equipment. AREA Tells where hazards may occur. HAZARD Tells what the hazard is. SAFEGUARDS Tells how to avoid the hazard. Always Read Manual and Train Operators Failure to read and understand the manual could cause equipment-related hazards to operators. All employees should read the equipment manual and have access to it at all times while operating Alpine equipment. Any employee operating, maintaining or servicing the equipment should read and understand the product manual, contacting Alpine Customer Service if additional clarity is required. Alpine Equipment customer service can be reached at 800-521-9790. Know Where E-Stop Switches are Located If equipment malfunctions or a situation becomes present where immediate shutoff is necessary. Employees should be trained on where to find Emergency Stop buttons and how to use them properly. Maintenance should be notified each time E-Stop is depressed and the cause should also be noted. Inspect Equipment Daily Broken or worn machine parts can cause damage to equipment. Never use equipment if you are unsure about its operational condition. Make note of any parts that look worn or broken and notify plant maintenance immediately. Stop using equipment immediately if any safety devices are broken or disabled. Cutting Equipment Cutting hazards are present with Alpine Linear and Component Saws. Be aware of sharp equipment edges and spinning blades. NEVER open saw cabinet unless blade is STOPPED and power is OFF Operate the Automill from the front or back of the saw, never on the side near the blades.