Issue link: http://alpine.uberflip.com/i/985331
12 AutoMill SC Motion Control Upgrade P R O D U C T M A N U A L EN 2.2. Motors and Feedback Cables The AutoMill SC Motion Control Upgrade includes six new servo motors and feedback cables for the following axis: Angle 1, Angle 2, Angle 3, Angle 4, Angle 5 and Carriage. NOTE All the 23 power cables, the remaining 17 servo motors and feedback cables are not replaced when upgrading the AutoMill SC with the Motion Control Upgrade. Table 4: New Servo Motors (refer to Figure 5-10) No. Item Description 1 Servo Motor Head 1 2 Servo Motor Head 2 3 Servo Motor Head 3 4 Servo Motor Head 4 5 Servo Motor Head 5 6 Servo Motor Carriage Figure 5 Figure 6 2.1.3. Cabinets Cooling System With the AutoMill SC Motion Control Upgrade, the cooling of the each of the control cabinets is upgraded from Vortec to Air Conditioners as they are more cost effective to operate. Table 3: Air Condition units (refer to Figures 3-4) No. Item 1 Fixed end AC unit 2 Movable end AC unit Figure 3 Figure 4