Issue link: http://alpine.uberflip.com/i/985331
21 AutoMill SC Motion Control Upgrade P R O D U C T M A N U A L EN NOTE Only one of the lengths defined below needs to be entered. The AutoMill SC Upgrade software will automatically calculate the remaining lengths. NOTE The pivot axis heights and lengths can be entered in feet-inches- sixteenths or in decimal inches. The deferent lengths are defined as below (Figures 34, 35) • OA LEN – Overall board length • Center Len – Centerline length • Top Len – Top length • Bot Len – Bottom length • PAL – Pivot axis length Figure 34 Figure 35 5. QTY TO CUT – Click or touch the box and enter the quantity required for the setup. 6. CANCEL – Cancels the current operation and returns the software to the Main Menu (Figure 21). 7. SETUP – Advances the software to Run Menu (Figure 27) using the defined cut parameters. Now follow the instructions to setup the AutoMill SC Upgrade in Section 4.2.1.2 which covers the Run Menu. 4.3.1. Board Select Menu Figure 30 1. Configuration Buttons – Click or touch the figure that is closest to the desired cut. The panel on the left "L" controls the left side of the board. The panel on the right "R" controls the right side of the board. 2. Angle Buttons – Click or touch the angle buttons to open the Angle Input Dialog Box (Figure 31). Angles 1 and 2 are shown on the left side of the board. Angles 3 and 4 are shown on the right side of the board. Figure 31 3. Height Buttons – Click or touch the height buttons to open the Height Input Dialog Box (Figure 32). Height 1 is the overall height of the lumber. Heights 2 and 3 correspond to the pivot axis heights. Figure 32 4. Length Buttons – Click or touch the length buttons to change the various lengths (Figure 33) Figure 33