Alpine Equipment Manuals

AutoMill SC Motion Control Upgrade

Issue link: http://alpine.uberflip.com/i/985331

Contents of this Issue

Navigation

Page 9 of 103

10 AutoMill SC Motion Control Upgrade P R O D U C T M A N U A L EN No. Item 18 Miniature Circuit Breaker, 6Amp 19 Miniature Circuit Breaker, 15Amp 20 Power Supply – 24V, 10Amp 21 Overload Protector, 9-14Amp 22 Overload Protector, 24-32Amp 23 Auxiliary Contact Block 24 Circuit Breaker, 60A 25 Contactor, 25Amp 26 Ground Bar 27 Fieldbus interface 28 Relay, 5Amp 29 Terminal block, 6-pin 30 Sercos, fieldbus interface 31 Fieldbus interface, power supply 32 Miniature Circuit Breaker, 2Amp 33 Contactor, 9Amp 34 Contactor, 40Amp 35 Lace bar 36 4 Conductor Double Deck Terminal Block 37 Contactor, 6Amp 2.1.2. Moving-end Control Cabinet Components All the components inside the Moving-end control cabinet are completely new. Table 2 includes all the components inside the moving-end control cabinet. Table 2: Moving-end Control Cabinet components (refer to Figure 2) No. Item 1 Back Panel 2 PBD 3P Miniature UL 1953 3 Terminal Block, 3 Cond 4 End Plate, Grey 5 Terminal Block – 2.5 WAGO 6 Fused Terminal Block 7 Relay Term. Block 24Vdc 8 Double Deck Term. Block 9 Terminal End Plate 10 End Plate Grey 11 End Clamp 6mm for TS35 12 End and intermediate plate 13 End and intermediate plate 14 10 Position 5.2mm Jumper 15 4 Conductor Green-Yellow Ground Term. Block 16 3 Conductor Ground Terminal Block 17 Servo Drives: APN 37254 – Absolute (A1, A2, CARR) APN 37255 – Resolver (All others)

Articles in this issue

view archives of Alpine Equipment Manuals - AutoMill SC Motion Control Upgrade