Alpine Equipment Manuals

AutoSet Plus Product Manual

Issue link: http://alpine.uberflip.com/i/935082

Contents of this Issue

Navigation

Page 32 of 155

33 AutoSet Plus P R O D U C T M A N U A L EN 12. Slide Acme nut on Acme rod and turn slowly until nut starts to run nut into the table 3"- 4" (Figure 82, 83) Note: This will put the axis out of calibration Figure 82 Figure 83 13. Install guide blocks on Acme shaft (Figure 84) Figure 84 14. Align and Install screws in motor mount on the opposite end of the axis NOTICE Insert all screws before tightening them. (Figure 85) 9. Turn axis until the Acme Nut becomes completely unthreaded (Figure 79) NOTE The axis will move toward the opposite side Figure 79 10. Remove ACME Nut by pushing the ACME rod into the table and tilting the acme nut until it can be removed (Figure 80) Figure 80 Install New Acme Nut: 11. Insert the New ACME Nut leaning toward the opposite side (Figure 81) Figure 81

Articles in this issue

view archives of Alpine Equipment Manuals - AutoSet Plus Product Manual