Issue link: http://alpine.uberflip.com/i/935082
34 AutoSet Plus P R O D U C T M A N U A L EN ! WARNING Verify that all power to the machine has been turned off following OSHA-approved lockout/tagout procedures (OSHA REGULATION 29 CFR 1910.147). 18. Tighten down the set screws in the bearing (Figure 87) Figure 87 19. Install side plate - Place plate on tabs and push down carefully 20. Remove lockout/tagout and power up 21. Calibrate the axis with the new nut (Section 5). Figure 85 15. Install bearing plate. Center bearing on axis such that the nut has play side to side in the slot before tightening bearing plate (Figure 84) NOTICE Polish or file the shaft to allow the bearing to slide on if needed. Do not tighten set screws at this time. Figure 86 16. Install the automated puck (Section 6.5.1) 17. Remove lockout/tagout and power up to move Puck to middle of table