Alpine Equipment Manuals

AutoSet Plus Product Manual

Issue link: http://alpine.uberflip.com/i/935082

Contents of this Issue

Navigation

Page 6 of 143

7 AutoSet Plus P R O D U C T M A N U A L EN Option 2: (Figure 2) 8 Automated axis per table, and 4 manual axis per table • O.C. spacing between two automated axis is 10-1/2in. • Each manual baseline axis is centered between two automated axis. Figure 2 2. Getting to Know the AutoSet Plus 2.1. Jigging system overview Each table consists of manual and automated pucks. The manual pucks are set in position and adjusted as needed using a ¾" wrench to loosen/tighten the pucks. The automated pucks are directly driven to position using a servo motors and lead screws. The automated pucks move to positions identified by the software. Figure 3

Articles in this issue

view archives of Alpine Equipment Manuals - AutoSet Plus Product Manual