Issue link: http://alpine.uberflip.com/i/935082
23 AutoSet Plus P R O D U C T M A N U A L EN 3.9. Move Individual Puck All pucks are assigned a location on the outside profile of the truss. Occasionally, it is useful to move a puck to another location on a board inside the truss. To move an individual puck, follow the steps below: 1. Select a puck to move by clicking on its axis, the axis will turn red (Figure 49) 1 Figure 49 2. Click on the board that you want the puck to brace. 3. A pop up box appears with two options: Top or Bottom edge (Figure 50) 4. Select to the location where you want to locate the puck. Figure 50 For example, in Figure 51, the puck number 7 was moved from the top edge of the top chord to the top edge of the bottom chord. Figure 51 3.8.2. Vertical dimension (Figure 47): To create vertical dimension, click on the vertical dimension icon then follow the steps below: 1. Click on a desired location to display the vertical dimension 2. Click on first point 3. Click on second point 2 1 3 Figure 47 3.8.3. Diagonal dimension (Figure 48): To create diagonal dimension, click on the diagonal dimension icon then follow the steps below: 1. Click on a desired location to display the diagonal dimension 2. Click on first point 3. Click on second point 2 1 3 Figure 48