Issue link: http://alpine.uberflip.com/i/586848
96 alpineitw.com (800) 521-9790 SAI SA SAT SA51 (SA68 Similar) HSAT HSA MSAI CSAI HSA HSAT CSAI MSAI SA SAI SAMT SAT STRAP ANCHORS Design Features… meet specifications for a variety of "wood-to- concrete or masonry" applications, including seismic anchorage for concrete walls-to-floor or roof diaphragms. For anchor down use, the SA/HSA series has a 1-piece design – no separate anchors are required. The required embedment is also shorter than for the AD/ ADA series. This makes the strap anchor and heavy strap anchor ideal items for the competitive construction trade. The SA series and the HSA series are considered unsatisfactory where any of the following exist: • A horizontal cold joint between the slab and the foundation wall or footing beneath, unless provisions are made to transfer the load. • They are installed in slabs poured over foundation walls formed of concrete block. • The members being anchored are less than 3 1 ⁄2" wide (wood splitting may occur when nailed). Minimum concrete strength must be 2000 psi for the allowable design loads. Listed values are verified by test using a safety factor of three. n SAI The SAI is designed especially for wood I-Joist; nail spacing minimizes wood splitting (10d x 1 1 ⁄2" nails 3" on-center). n SA/SAT The standard straight strap anchor attaches to the top of the purlin; it must be embedded 4". The minimum edge distance is 5". The SAT provides a 90° twist in the strap; it attaches to the side of the purlin. It must be embedded 4". The minimum edge distance is 5". n SA51/SA68 The SA51/SA68 has a range of nails from a minimum of 9–16d to a maximum of 24–16d. Extra nail holes are provided. Loads can be calculated according to the code up to a maximum of 4610 lbs. n HSA 10KIPS Heavy loaded strap anchor made from 10 ga. galvanized steel by 3" section. This strap anchor is the heaviest anchor manufactured in the industry. Use for commercial trusses and glu-lam construction. n HSA 10KIPS Heavy loaded strap anchor made from 10 ga. galvanized steel by 3" section. This strap anchor is the heaviest anchor manufactured in the industry. Use for commercial trusses and glu-lam construction. n HSA/HSAT The heavy strap anchor is embedded 6" for the HSA28 and 8 1 ⁄4" for the HSA35. The minimum edge distance is 5". The HSAT provides a 90° twist in the strap and it attaches to the side of the purlin. The HSA and the HSAT have an increased metal cross section and hook depth to provide a load-carrying capacity above design loads of the standard SA series. n CSAI The CSAI is designed for concrete embedments and may be used on a wide variety of composite wood products including 3 1 ⁄2" wide wood I-joists and open web trusses. n MSAI The MSAI is designed for masonry unit block wall construction and may be used on a wide variety of composite wood products including 3 1 ⁄2" wide wood I-joists and open web trusses. The masonry embedment line on the MSAI allows for 4" of grout embedment in a standard 8" concrete masonry unit. Note: The CSAI is manufactured from 18 ga. galvanized steel which can be installed with air gun nailers. This eliminates the high labor cost of hand nailing. Material… HSA 10KIP/HSA/HSAT – 10 ga. galvanized steel. SA/SAI/SAT/SAMT – 12 ga. galvanized steel. CSAI – 18 ga. galvanized steel. MSAI – 14 ga. galvanized steel.