Loading Class Manual for intelliVIEW – Chapter 10
Working with a Cantilevered Hip Condition
The diagram to the left illustrates a corner set that is
cantilevered 3' and has a 1' overhang. The trusses labeled CJ1,
CJ3 and CJ5 will require additional support (bearing) at the end
of their overhangs. This support member is referred to as a
Structural Sub-fascia. In turn the structural sub-fascia is
supported by the hip jack (HJ10) and another truss. During this
lesson we will our discussion to loading the hip jack (HJ10).
Applying the load can be done either in iDesign or by using Load
Transfer from iModel.
Loading using iDesign
Assuming that the truss has been created and is loaded into iDesign
1. Select the Loading icon
2. Select the Add Load case icon
3. Select the HipJack tab and the Add Loads dialog box opens
