Issue link: http://alpine.uberflip.com/i/835317
3 SmartView P R O D U C T M A N U A L EN 1. Introduction IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PROVIDE THIS INFORMATION TO THE OPERATOR OF THE EQUIPMENT. ADDITIONAL COPIES ARE AVAILABLE, CALL ALPINE EQUIPMENT CUSTOMER SERVICE: 800-521-9790. Disclaimer The information contained in this document is believed to be accurate in all respects but is not warranted by Alpine. The information is subject to change without notice and should not be construed in any way as a commitment by Alpine. Alpine assumes no responsibility for any errors or omissions in this document. Every reasonable effort is made to keep this document current, but in the event of discrepancy, Alpine engineering documentation, installation and service and safety procedures shall prevail. Copyright ©2017 by Alpine, a division of ITW Building Components Group Inc. All rights reserved. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written consent of the publisher. Contents 1. Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 1.1. SmartView Features List . . . . . . . . . . . . . . . . . . . 3 1.2. System Overview . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. SmartView User Interface . . . . . . . . . . . . . . . . . . . . . 4 2.1. Truss Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 2.2. Plate Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 2.3. Board Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 3. Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 1.1. SmartView Feature List • Key truss build information such as span, height, lumber sizes, and overhang. • Custom dimension capability to the table system. • Synchronize view of truss being built. • Detailed truss dimensions for assembly. • Zoom view for boards and plate placement. • Production timer for operator motivation. • Ability to daisy chain TVs for easy viewing. • Different Colors highlight key details, such as plate gauge, board width and part location. • Interactive display (not just a .pdf ) reduces builders' questions. 1.2. System Overview Each SmartView system consists of software running on the production table computer, and a second computer installed behind the TV, mounted above the table. A second SmartView system can be installed to allow display of two different truss set ups at the same time. To have multiple views of the truss along the table, the HDMI signal from one SmartView can be daisy chained to additional TVs using an HDMI splitter. The SmartView software automatically loads the correct truss from the automated table. Any changes made at the SmartView software main control screen will automatically be mirrored on the TV(s) as well. For example, zooming in on the truss will be visible on the computer screen as well as on the TV displays.