Alpine Training

l Discard and Exit Field Synchronization Setup. SelectthisoptiontoexittheFieldSynchronizationmodewithoutsavinganychangesthatmayhavebeen made.Forexample,anyfieldswhichwerealreadysettosyncpriortoenteringthesetupmodewouldstill remainsync'd. l Save and Exit Field Synchronization Setup. SelectthisoptiontosavemodifiedfieldselectionsandexittheFieldSynchronizationmode. l Last Saved Field Synchronization Setup. Select this option to reset the synchronization to the last saved settings. This assumes you have not alreadysavednewsettingssincethelastsavedsettings. l Color Preference. (RefertothisexplanationintheStarting the Field Synchronizationsectionabove). Note: This topic information is located in the iCommand software Help Menu labeled: Administration Menu Help.TheTableofContentspath=Administration/FieldSynchronizationtopic. www.alpineitw.com Page-66 CustomerSupport:866-237-2878

• Cover
• Table of Contents
• What's New in Release
• Where is Help Documentation Found?
• New Attic Tools
• Add Floor Truss Section to Attic (Add Opening Enhancement) (iDesign Help)
• Add to Component Catalog (iDesign Help)
• Apply Attics with Floor Truss Condition to Layouts (iModel Help)
• Move Opening Enhancements (iDesign Help)
• Notes
• Component Match Tools
• Component Match Preferences
• Component Match Tool (iModel & iDesign Help)
• Create a Component Catalog (iC-Administration Help Menu)
• Manage Component Catalog (iC-Administration Help Menu)
• Message Center (Settings Help)
• Notes
• Additional New IntelliVIEW Features
• Parapet End Condition Tool in Layout (iModel Help)
• Snow Drift Tab in Uniform Loads (iDesign Help)
• Removal of Custom Building Code / Addition of CRC & CBC Codes (Settings Help)
• New NDS 2015 Lumber Value Set (Settings Help)
• Improved Select Filter - Select Options (iModel)
• Simpson Construction Hardware (iSource)
• Notes
• Component Draw / Production Draw
• Warning Notes on Component & Production Drawings
• iCommand Features (Administration Menu)
• Field Synchronization (Administration Menu)