Alpine Training

l Cancel button. If youdecidethat youdonot want toapply any matchedcomponents tothelayout at this time, click the buttonlabeledCanceltostoptheComponentMatchprocesswithnochangesmadeandclosetheCom- ponent Matchdialogwindow. Aprompt is displayedrequestingyoutoverify if youwant toexit theCom- ponentMatch(Figure-20).SelectthebuttonlabeledYesorNoasappropriate. Figure-20 Note:ThistopicinformationislocatedinthesoftwareHelpMenulabeled:iModel Help.TheTableofContents path=iModelMenus& Tools/JobDesigner/ComponentMatchtopic. www.alpineitw.com Page-33 CustomerSupport:866-237-2878

• Cover
• Table of Contents
• What's New in Release
• Where is Help Documentation Found?
• New Attic Tools
• Add Floor Truss Section to Attic (Add Opening Enhancement) (iDesign Help)
• Add to Component Catalog (iDesign Help)
• Apply Attics with Floor Truss Condition to Layouts (iModel Help)
• Move Opening Enhancements (iDesign Help)
• Notes
• Component Match Tools
• Component Match Preferences
• Component Match Tool (iModel & iDesign Help)
• Create a Component Catalog (iC-Administration Help Menu)
• Manage Component Catalog (iC-Administration Help Menu)
• Message Center (Settings Help)
• Notes
• Additional New IntelliVIEW Features
• Parapet End Condition Tool in Layout (iModel Help)
• Snow Drift Tab in Uniform Loads (iDesign Help)
• Removal of Custom Building Code / Addition of CRC & CBC Codes (Settings Help)
• New NDS 2015 Lumber Value Set (Settings Help)
• Improved Select Filter - Select Options (iModel)
• Simpson Construction Hardware (iSource)
• Notes
• Component Draw / Production Draw
• Warning Notes on Component & Production Drawings
• iCommand Features (Administration Menu)
• Field Synchronization (Administration Menu)