Issue link: http://alpine.uberflip.com/i/751299
2 ALS 276 MOTION CONTROL UPGRADE PACKAGE I N S TA L L AT I O N G U I D E EN ! WARNING Read the following warnings before using this equipment. IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PROVIDE THIS INFORMATION TO THE OPERATOR OF THE EQUIPMENT. READ THE MANUAL Before operating equipment, read and understand all safety, operation and maintenance information provided in the operation manual. HOT SURFACE HAZARD Contact may cause burns. Allow to cool before servicing. WEAR SAFETY GLASSES Failure to wear safety glasses with side shields could result in serious eye injury or blindness. KEEP EQUIPMENT GUARDS IN PLACE Do not operate the equipment if the safety devices have been removed. OPERATOR TRAINING All personnel must be trained before operating equipment. KNOW WHERE AND HOW TO SHUT OFF THE EQUIPMENT IN CASE OF AN EMERGENCY DE-ENERGIZE, DEPRESSURIZE, DISCONNECT AND LOCK OUT ALL POWER SOURCES DURING MAINTENANCE Failure to de-energize, disconnect and lock out all power supplies before performing equipment maintenance could cause serious injury or death. EQUIPMENT MISUSE HAZARD Equipment misuse can cause the equip ment to rupture, malfunction, or start unexpectedly and result in serious injury. Tools Needed: • Wire Cutter • #2 Phillips Head Screw Driver • Terminal Block Insulated Flat Head Screw Driver • Digital Multimeter • Wire Stripper • Flat Head Screwdriver • Wire Crimper • 3/8 in. Socket or Combination Wrench Read the following safety information before using this equipment: In this installation guide, the words WARNING, CAUTION and NOTE are used to emphasize important safety information as follows: ! CAUTION Hazards or unsafe practices that could result in minor personal injury, product or property damage. ! WARNING Hazards or unsafe practices that could result in severe personal injury, death or substantial property damage. NOTE Important installation, operation or maintenance information. Included equipment: ALS 276 Motion Control Upgrade Part Number: 37124 • (1) Motion Controller with Power Supply • (3) 6A Servo Drives • (3) 10A Servo Drives • (1) Spare Parts Kit (Screws, Washers, Terminal Blocks) • (2) Multipoint Cables • (12) Blue Spade Plugs • (1) 2 ft. Length of Blue 16 AWG Wire • (5) ½ Meter EtherCAT Cables • (2) 1 Meter EtherCAT Cables • (6) Feedback Converter Cables • (1) 10 ft. USB to Mini USB Cable For more information, see Alpine Manual M1002—"Equipment Safety Precautions". Extra copies of the safety procedures can be ordered by calling 800-521-9790.