Alpine Equipment Manuals

ALS 276 Motion Control Upgrade

Issue link: http://alpine.uberflip.com/i/751299

Contents of this Issue

Navigation

Page 5 of 31

6 ALS 276 MOTION CONTROL UPGRADE PACKAGE I N S TA L L AT I O N G U I D E EN Z-Axis Brake Relay Modification: NOTE Brake relay is located on CR-7 coil (in block that contains CR-1 to CR-9) NOTE TB3-1 (Blue) wire is positive voltage; White wire with blue stripe is negative voltage 1. Move TB3-1 (Blue) from A1 of CR-7 to A2 of CR-7 (see "before") (Fig. 7) 2. Using included Blue wire, run from TB3 + terminal to A1 of CR-7 (see "after") (Fig. 8) 3. See electrical schematic for circuit (Fig. 15) ! CAUTION If you are unsure about this process, call Alpine Customer Service at 800-521-9790, as improper wiring could cause damage to electrical circuit Fig. 7 (before) Fig. 8 (after) Connecting Printer to New Controller: Connect printer communication cable to COM2 port (RS-232) on master controller

Articles in this issue

view archives of Alpine Equipment Manuals - ALS 276 Motion Control Upgrade