Alpine Equipment Manuals

19 AutoSet C4 ™ P R O D U C T M A N U A L EN Grease Point Figure 36 ! CAUTION Applying too much grease into a sealed bearing will blow the seals. Use caution when greasing the guide wheels. • Using compressed air, blow out the slots containing the acme rods on which the AutoSet C4 pucks travel. • Lubricate the acme rods using WD-40. NOTE Environmental factors may require more frequent lubrication. • Once the acme rods have been lubricated, run the pucks the full length of the table. This will ensure even lubrication and will clean the acme rod. • Visually inspect the AutoSet C4 motor coupling to verify it is not separating from the motor. • Visually inspect the gantry gearbox for leaks. If the gearbox is leaking contact Alpine Equipment Technical Support. • Visually inspect guide assemblies for damage. If the guides appear damaged contact Alpine Equipment Technical Support. • Visually inspect the AutoSet C4 motor and motor mount to verify all the hardware has remained tightened. If loose, remove the screws, apply a medium strength thread-locker and replace the screws. 6.4. Daily Maintenance • Check for proper operation of all safety devices (E-Stop and Limit Switch). ! WARNING Repair or replace safety devices if they are not in operating condition. • Clean debris from the table top and the cable trough (Figure 32). • Inspect the Energy Chain for loose or damaged links. • Drain water from the lter regulator and air compressor tank. 6.5. Weekly Maintenance • Inspect all air lines and solenoid valves (Figure 34). Figure 34 • Listen for leaks and replace lines/valves are are leaking. • Inspect guide wheels for even wear indicating they are positioned properly (Figure 35). Check for even wear in the center for the wheel. Figure 35 • Check that the gap between all the guide wheels and the table frame are within 1/32nd of an inch. • Grease the guide wheels (Figure 36).

• Cover