1 2 3 4 5 6 7 8
5.06
VARIABLE ANGLE TRUSS WEB-TO-WEB CONNECTIONS
Reference Standard Details
Please refer to these Standard Details for
information regarding the selection of TTC clip
sizes, and the required quantities and placement
locations of fasteners:
TS025, TSO25B, TSO25C 45° corner set
TS025A non-45° corner set
TS056 rafters
TS056A rafters
Maximum Connection Reactions
Refer to the referenced Standard Details for
allowable loads.
Connections using TTC Clips
Supported
truss
TTC clip
Girder truss
Description
Truss-to-truss connections of variable angles
may be made at the truss vertical webs by using
TTC clips. TTC clips may be used to fasten
supported trusses to single-ply girder trusses.
They are especially useful for making
connections for hip jacks and corner jacks in hip
sets.
Fasteners
These connections are made with #10 self-
drilling tapping screws.
TTC clips may also be used for rafter
to truss connections.
Connections at Gable Outlookers Using ITWBCG Hardware Connectors
Outlooker "C" member
TSJH Connector
Fascia member
End gable truss
(dropped-top gable)
HT2.5A
Description
In gable outlooker situations, CFS "C" framing
may be attached to TrusSteel trusses using stud
material and ITWBCG Hardware HT2.5A
connectors.
Fasteners
These connectors are attached to the trusses
and the "C" framing with #10 self-drilling
tapping screws.
Reference Standard Details
Please refer to the Standard Detail below for
information regarding the selection of HT2.5A
connectors and installation requirements:
TS041
Connections at Gable Outlookers
ENGINEERED BY ALPINE
CO N N E C T I O N S / D E TA I L S
Stud Material
