21
AutoSet C4
™
P R O D U C T M A N U A L
EN
6.9. Yearly Maintenance
• Check that the table is level.
!
CAUTION
If the table is not level contact Alpine Equipment Technical
Support before adjusting the leveling legs.
• If necessary, adjust the leveling legs (Figure 40).
Jam Nuts Center Support Leg
Figure 40
• Tighten Center Support Leg to stien the table.
• Check the gearbox uid level.
NOTE
The gearbox is filled with oil and does not require changing.
However, the oil level should be checked yearly.
• For US Motors CBN Gearboxes use Mobil SHC629
synthetic gear oil.
• Fr Dodge Quantis Gearboxes use Mobilgear 630
mineral oil.
Step 5. Loosen the Jack Bolts and tighten the bolts
on the bearing (Figure 39).
Step 6. Re-tension the drive chain (Section 6.1)
Step 7. Replace all covers.
Step 8. Perform another test press to verify 100%
embedment on the top plate and 50% on
the bottom plate.
6.7. Monthly Maintenance
• Check the drive chain tension and adjust as
needed (Section 6.1).
• Lubricate the drive chain using a roller chain
lubricant.
6.8. Quarterly Maintenance
• Remove the bearing cover and grease the roll
bearings at each end of the gantry head using two
pumps of NLGI Grade 2 grease.
• Grease bearings on AutoSet C4 rods.
• Check the roll conveyor belts for tension and
wear. A worn belt will look shiny. Adjust the belt
tensioner if the belt is slipping.
