Alpine Equipment Manuals

ALS 4.0 Linear Saw

Issue link: http://alpine.uberflip.com/i/530982

Contents of this Issue

Navigation

Page 56 of 227

57 ALS 4.0 P R O D U C T M A N U A L EN Step 4 – Use an 8mm Allen wrench to remove the cap screws from the trunnion mount at the top of the actuator. Carefully lift the actuator up and remove it through the top of the machine. The location of the cap screws and trunnion are shown in Figure 166. Figure 166 5.5.2. Removing the Z1 Actuator Step 1 – Before removing the Z1 actuator, make sure the head is all the way down against the bottom hard stops. Disconnect power from the ALS 4.0 and lockout/ tag out the machine. Now unplug power and feedback cables from the top of the actuator. ! CAUTION Failure to disconnect the power from the machine before removing the cables is not only dangerous, it WILL damage the actuator. Step 2 – Start removing the actuator by releasing the rod end that is attached to the Z-axis slide. Remove the four socket head cap screws from the bottom of the casting using an 8mm Allen wrench as shown in the Figure 165. Figure 165 Step 3 – With the rod end of the actuator free remove the right-hand roof panel. Use a 5/32" Allen wrench to remove the 11 cap screws around the perimeter of the roof panel and a 7/16" flat wrench to remove the five hex head screws that attach the right-hand panel to the middle panel. Set the removed panel aside. This will provide the necessary clearance for the Z1 actuator to be removed through the top of the saw cabinet.

Articles in this issue

view archives of Alpine Equipment Manuals - ALS 4.0 Linear Saw