Alpine Equipment Manuals

ALS 4.0 Linear Saw

Issue link: http://alpine.uberflip.com/i/530982

Contents of this Issue

Navigation

Page 41 of 227

42 ALS 4.0 P R O D U C T M A N U A L EN Step 7 – Move Z1 to "2" using the "Move Z1" button on the Manual Control Screen. Figure 119 Step 8 – Start the blade using the "Saw Motor On" button on the Manual Control Screen. Figure 120 Step 9 – Manually Jog T1 forward until a groove has been cut across the full width of the lumber using the "Jog T1 Fwd" button on the Manual Control Screen. Figure 121 Figure 122 Step 10 – Move Z1 back to "0.0" using the "Z1 Move" button on the Manual Control Screen. Figure 123 4.10 Check Alignment of the T/Z Slide & Belt Feeders Step 1 – Place a piece of machined lumber that is at least 7.25" wide across the L1 and L2 belts. Step 2 – Engage the L1 & L2 Pushers by pressing the "L1 Pusher In" and "L2 Pusher In" buttons on the Manual Control Screen. Figure 114 Step 3 – Engage the L1 & L2 Clamps by pressing the "L1 Clamp Down" and "L2 Clamp Down" buttons on the Manual Control Screen. Figure 115 Step 4 – Move B1 to "0" using the "Move B1" button on the Manual Control Screen. Figure 116 Step 5 – Move A1 to "90" using the "Move A1" button on the Manual Control Screen. Figure 117 Step 6 – Move T1 to "-2" using the "Move T1" button on the Manual Control Screen Figure 118

Articles in this issue

view archives of Alpine Equipment Manuals - ALS 4.0 Linear Saw