Issue link: http://alpine.uberflip.com/i/530982
28 ALS 4.0 P R O D U C T M A N U A L EN The following describes the function of each button: 1. LIVEDECK FWD – Starts live deck moving to saw 2. LIVEDECK STOP – Stops live deck movement 3. INFEED ROLL CLAMP DOWN – Lowers infeed roll clamp assembly 4. INFEED ROLL CLAMP UP – Raises infeed roll clamp assembly up 5. CLAMP ARM IN – Pulls clamp arm in 6. CLAMP ARM OUT – Extends clamp arm 7. BOARD CLAMP OPEN – Opens clamp jaws 8. BOARD CLAMP CLOSE –Closes clamp jaws 9. LOAD LUMBER FROM LIVEDECK – Perform complete lumber load sequence 10. EJECT LUMBER – Eject any lumber inside of saw 11. STOP ALL – Stop all lumber loading operations 12. Exit – Leave this dialog 3.13 INI Files AEPsaw.ini is a file that contains parameters that affect the operation of the ALS 4.0. ! CAUTION Do NOT change these parameters without specific instructions from an Alpine Equipment Customer Service. AlpineLE.ini is a file that contains motion control parameters; these should only be changed by Alpine Equipment Customer Service. ! WARNING Changes to settings in this file can damage the machine and will void the warranty. This screen allows user to view current Pick List, Current Run List (the actual list of stock fills which are sent to the saw to be cut, and in this exact order), and a new feature, the Graphical View (Figure 54). This is a graphical representation of all of the stock fills for an entire job. The NEXT button can be used to see the following set of stock fills. Figure 54 3.12 Auto Infeed System If the ALS is equipped with the optional Auto Infeed System, the panel panel in Figure 55 will allow control over the system. This panel can be accessed from the home screen and in all modes of operation. 9 10 11 12 2 4 6 8 1 3 5 7 Figure 55