Issue link: http://alpine.uberflip.com/i/530982
15 ALS 4.0 P R O D U C T M A N U A L EN 3.4.1 Setting up Cuts Change the default angles and heights to match the piece clicking or touching the buttons below the piece diagram. As these buttons are clicked or touched, a keypad will appear (Figure 22). Use this keypad to enter the correct data. Figure 22 Figure 23 The SIZE and GRADE buttons will bring up screens when clicked. Here, the appropriate entries can be chosen. Within this dialogue box the following can be changed: • SPEED – Allows the system speed to be adjusted per stock entry. It is percentage based with 100% being full speed. • CHECK ALL – Selects all with a single selection • CLEAR ALL – Deselects all with a single selection • EXIT – Exits the dialog COST can be entered allowing the saw to calculate the lumber cost per the job pick list. Cost is based on board feet. The cost information must be manually entered and updated. The SAVE button will save all progress. 3.4 Semi-Automatic Operation Figure 20 Enter the Semi-Automatic Mode by clicking or touching the button shown in Figure 20 on the Main Screen. The following screen will appear (Figure 21): 1 6 3 4 5 7 2 Figure 21 The default piece for this screen has square cuts on each end. Choose the ends that most closely match the piece required. In the example above, the single cut button has been selected for the left end and the single cut for the right end. The selections can be changed at any time as cuts are setup in this mode.