Issue link: http://alpine.uberflip.com/i/493471
1 2 3 4 5 6 7 8 5.12 ITWBCG Part GTH2 GTH2 Single-Ply TrusSteel Top Chord TSC2.75 w/ Seat Plate TSC4.00 w/ Seat Plate Mil (GA) Range 28-43 (22-18) 28-54 (22-16) Capacity LBS (kN) 4110 (18.28) 4110 (18.28) Standard Detail TS050 TS050 GTH2 GTH2 GTH2 GTH2 GTH2 GTH2 GTH2 28TSC2.75 w/o Seat Plate 33TSC2.75 w/o Seat Plate 43TSC2.75 w/o Seat Plate 28TSC4.00 w/o Seat Plate 33TSC4.00 w/o Seat Plate 43TSC4.00 w/o Seat Plate 54TSC4.00 w/o Seat Plate 28 (22) 33 (20) 43 (18) 28 (22) 33 (20) 43 (18) 54 (16) 870 (3.87) 1220 (5.43) 1270 (5.65) 810 (3.60) 1140 (5.07) 2100 (9.34) 2530 (11.25) TS051 TS051 TS051 TS051 TS051 TS051 TS051 ITWBCG Part GTH2 GTH4 GTH2 Two-Ply TrusSteel Top Chord TSC2.75 w/ Seat Plate TSC4.00 w/ Seat Plate TSC2.75 w/o Seat Plate Mil (GA) Range 28-43 (22-18) 28-54 (22-16) 28-43 (22-18) Capacity LBS (kN) 5050 (22.46) 5290 (23.53) 1270 (5.65) Standard Detail TS052 TS054 TS053 ITWBCG Part GTH3 Three-Ply TrusSteel Top Chord TSC2.75 w/ Seat Plate Mil (GA) Range 28-43 (22-18) Capacity LBS (kN) 6580 (29.27) Standard Detail TS055 Connections using Alpine Hardware GTH Connectors Description CFS trusses may be attached to concrete bearings using GTH connectors. Several sizes of GTH connectors are available, depending upon the required load transfer capability. Fasteners These connectors are attached to the truss with #10 self-drilling tapping screws and the connectors are fastened to the concrete bearing using threaded rods which are installed into the concrete using an epoxy adhesive. Reference Standard Details TrusSteel truss anchored to concrete bearing using Alpine Hardware GTH-series connector and epoxy- installed threaded rod. EMBEDDED CONNECTIONS TO CONCRETE Please refer to the Standard Details shown in the chart below for information regarding the selection of GTH connectors, sizes and installation requirements: TS050 TS051 TS052 TS053 TS054 TS055 Maximum Connection Reactions - Uplift ENGINEERED BY ALPINE CO N N E C T I O N S / D E TA I L S