Issue link: http://alpine.uberflip.com/i/221331
STEEL STUD HARDWARE SCREWS SCREWS Design Features . . most structural hardware items can be converted for use with light gage steel construction. The hole patterns may differ slightly from those products manufactured for use in general wood construction. No.10 screws are general fasteners for steel construction. To achieve stated loads, shear capacity must be equal to or greater than the table value. ST/CA ST/CAS CLIP ANCHORS/SKEWED Design Features . . the ST/CA and ST/CAS angles are multi-use reinforcing angles and can be field skewed to a maximum of 135°. Material . . 18 ga. and 16 ga. galvanized steel. Installation . . all specified fasteners must be used to achieve design loads. DESCRIPTION FINISH #10 x 1" Hex Zinc 330 #10 x 1" Philips Zinc 330 #10 x 1¹⁄₂" Philips Zinc SCREWS LOAD 330 ST/CA ST/CAS ST/CA 50 ST/CAS 50 WALL ANCHORS ST/WA . . three anchor ST/WAH14 Design Features availablewall use in steel configurations are for ST/WA ST/WA stud construction. The ST/WA and ST/ WAM14 are suited for both retrofit and new construction. Material . . 14 ga. and 12 ga. galvanized steel. Installation . . all specified fasteners must be used to achieve design loads. ST/AD ST/AD ST/RS ANCHOR DOWNS Design Features . . three configurations are available for easy steel stud installation. The narrow width accommodates inside dimensions of steel studs, while the lessened heights will not interfere with knockouts. Material . . ST/AD8, 10 ga. body with ³⁄₈" base; ST/AD10, ST/AD15, 7 ga. with ¹⁄₂" base. Installation . . all specified fasteners must be used to achieve design loads. The anchor bolt is ⁷⁄₈" x (ST/AD8) and 1" x (ST/AD10 and ST/AD15). Length specified by the engineer. Finish . . SUPERSPEED gray paint. ST/AD ST/AD10 PRODUCT CODE DIMENSIONS (INCHES) SCREWS #10 TO STUD W H ST/AD8 2¹⁄₂ 13⁷⁄₈ 24 ST/AD10 2¹⁄₂ 16¹⁄₈ 30 ST/AD15 2³⁄₄ 21¹⁄₂ 48 ST/AD10 ST/R ST/RS ROOF HANGERS Design Features . . both the ST/R and ST/ RS style hangers can be adapted for steel stud use. The ST/R hangers provide top and bottom channel support, while the RS hangers achieve required loads through seat-bearing. Material . . ST/R, 12 ga. steel stirrup; ST/ RS, 14 ga. and 12 ga. galvanized steel. Installation . . both hanger styles can be welded to steel headers. The ST/R style can be sloped and/or skewed, while the ST/RS can be sloped as needed. Finish . . SUPERSPEED gray paint. ST/RS410 ST/R410 NOTE These items are a sampling of the product which can be converted for steel stud usage. Please contact factory for additional information. 44