Issue link: http://alpine.uberflip.com/i/1399321
60 ALS 4.0 XE P R O D U C T M A N U A L EN NOTE The button that will then change to read "Enable Axes" as shown in Figure 167. Figure 167 Figure 168 shows the Z-axis sitting on hard stops which prevent the axis from moving down any further. Figure 168 Step 6 – Lock out and tag out to ensure it is safe to begin working inside the machine. ! CAUTION Always use OSHA approved lock out tag out procedure. Step 7 – Open door. Step 8 – Remove cover by removing the 6 screws on top. NOTE This will be a tight fit with the top on the machine. Figure 169 shows the screw locations with the top of the machine removed. Step 3 – Enable the Axes by clicking or touching the button shown in Figure 164. NOTE When axes are enabled the button will read "Disable Axes," and when the axes are disabled the button will read "Enable Axes." Figure 164 Step 4 – Jog Z1 down by selecting the Z-1-Axis first (Shown with the Arrow) and then pressing the button "Jog Z1 Down" to End Stop (Shown circled),The Saw will Beep and stop. Refer Figure 165. Figure 165 Step 5 – Disable Axes using the "Disable Axes" button shown in Figure 166. Look at the drive status if each Axis on the left is marked with a red "x" it means the Axes are disabled. Figure 166