Issue link: http://alpine.uberflip.com/i/1399321
58 ALS 4.0 XE P R O D U C T M A N U A L EN Outfeed Queue Conveyor: There are 3 shafts under the outfeed queue. Remove the guards around the two farthest from the saw cabinet and grease the bearings on each side of the shaft. Do not remove the guard plate the motor is mounted to. These fittings can be accessed without removing the motor (6 total). Figure 156 Trash Incline: There are four bearings on the trash incline—2 on the drive roller at the top of the incline (only one is shown in the picture on the right) and 2 more on the idler end at the bottom of the incline, just under the drive end of the trash/small parts conveyor (4 total). Figure 157 Trash/Small Parts Conveyor: Similar to the trash incline, there are four bearings on the trash/small parts conveyor—2 on the drive roller on the infeed side of the saw cabinet, and 2 more on the idler end on the outfeed side, as shown in the picture on the right taken from behind the machine (4 total). Figure 158 L1 & L2 Clamps: On the back of the saw cabinet, there are 2 sets of grease blocks, one for the L1 Clamp bearings, and one for the L2 Clamp bearings. Each set has 4 fittings (8 total). Figure 153 T1 Bearings: There are 2 grease fittings at the back of the head (as shown in the picture on the right) and 2 more at the front (4 total). Figure 154 Z1 Bearings: There are 2 grease fittings on the bottom of the head (as shown in the picture on the right) and 2 more on the top (4 total). Figure 155