Issue link: http://alpine.uberflip.com/i/1399321
48 ALS 4.0 XE P R O D U C T M A N U A L EN Step 12 – Stop the blade using the "Saw Motor Off " button on the Manual Control Screen. Figure 129 Step 13 – Release the L1 & L2 Clamps using the "L1 Clamp Up" and "L2 Clamp Up" buttons on the Manual Control Screen. Figure 130 Step 14 – Release the L1 & L2 Pushers using the "L1 Pusher Out" and "L2 Pusher Out" buttons on the Manual Control Screen. Figure 131 Step 15 – Using a framing square on the surface of the board that was against the fence, check the groove as shown. Figure 132 If the cut is square, the calibration procedure has been successfully completed. ! WARNING If the cut is not square, contact Alpine Equipment Customer Service for proper procedures, failure to follow proper procedures may result in damage to machine. Step 9 – Manually Jog T1 forward until a groove has been cut across the full width of the lumber using the "Jog T1 Fwd" button on the Manual Control Screen. Figure 125 Figure 126 Step 10 – Move Z1 back to "0.0" using the "Z1 Move" button on the Manual Control Screen. Figure 127 Step 11 – Move A1 to 90° using the "A1 Move" button on the Manual Control Screen. Figure 128