Issue link: http://alpine.uberflip.com/i/126813
LS LIGHT SLOPED HANGERS Design Features . . used on existing structures to increase strength for the attachment of joists to headers. Slip the hanger into place and adjust the seat (sloped either up or down). Use the hole in the bottom of the seat to set the hanger to the joist. Complete nailing to the header flanges or use for new construction needs. These hangers offer complete installation flexibility before, during or after joists are erected. 2xs Material . . 18 ga. galvanized steel. Loads . . larger seat-bearing and designed direct nailing provide proper installation of all nails into joist hangers. Special . . the LS eliminates slope hanger mixups and delays (any slope up or down, to and including, ¹²⁄₁₂ pitch). LS210 LSS LIGHT SLOPED/SKEWED HANGERS Design Features . . combination sloped skewed hangers offer further standardization and construction economy. They also provide compatibility with the SUPERSPEED line of S standard joist hangers. LSS hangers can be used to connect rafters to ridge beams in vaulted roof structures. 2xs, 3xs, 4xs, double 2x-s and wood I-joist sizes. Material . . 18 ga., 16 ga., and 14 ga. galvanized steel. Loads . . larger seat-bearing and designed direct nailing provide proper installation of all nails into joist hangers. Special . . LSS eliminates skewed and sloped hanger mix-ups and delays (any slope up or down, to and including, a ¹²⁄₁₂ pitch and any skew right or left up to 45°). A Flange Ordering/Specifying Information . .The LSS5.12 must be factory skewed 0° to 45°. It may be field sloped to 45°. (LSS4.12 and LSS3510-2 are similar) Configurations of some models may differ from those shown. LSS210 Slotted Holes Are Provided for Skewable Field Bending Application SSC SLOPED SEAT CONNECTORS Design Features . . allow fastening of solid and wood I-joists to the plate at any slope from 1:12 to 6:12. The SSC eliminates the need for costly rafter notching, bevel plates and toe-nailing. Install twelve nails to the plate and four to the joist. Material . . 18 ga. galvanized steel. Special . . the SSC was developed for wood I-joist beams to eliminate the need for bird cuts in the bottom chord. SSC2 10 www.itwbcghardware.com - 800.521.9790 ITW BCG Hardware