Alpine

ATH418 ADJUSTABLE TRUSS HANGERS ATH . the hanger's long ATHSL Design Features .bent to the required header straps can be field height ATHSR of the truss. The joist side flanges have round ATHSL218 holes so that the nails can be driven straight into the joist and regular nailing straight into the header flange. This hanger has been designed and developed for the truss plated industry. 2xs, 4xs and double 2xs. Material . . 18 ga. and 16 ga. galvanized steel. Loads . . nailing schedule and design load capacities are consistent with those obtained in independent laboratory tests. Special . . the ATH series offers a wide application flexibility, particularly to the truss plated industry, including five different versions: (1) Ceiling hanger (2) Universal or face mount hanger (3) Top flange hanger (4) Top flange over the back hanger (5) Skewed hanger at 45° (right & left) Stocked skewed hangers are designed for standardization and construction economies, and to provide compatibility with the ATH hanger hardware line. "Slant Nailing" (Toe Nailing) Drive Full Length Common Nails at 45° into Joist for Header Connection ATHIS (L & R) ATHS (L & R) Installation Sequence Rotate acute side to desired angle Align back edge of carried member to the slotted holes in seat of ATHSL hanger. Step 1 Install carried member into the seat of the hanger. Secure with 4 10d x 1¹⁄₂ nails. Rotate to the desired angle. Step 2 Install 10d nails into header on the acute angle side first. ADJUSTABLE TRUSS HANGERS ATHI ATHISL I-JOIST Design Features . . designed for the wood ATHISR I-joists industry, the ATHI has long header Step 3 Adjust acute side of hanger to the desired angle. Step 4 Adjust obtuse side of hanger flush with the carrying member. Install 10d nails into header on obtuse side. ATHI straps that can be field-bent to the required height of the truss. Positive angle nailing helps eliminate splitting of the I-joist's bottom chord. Material . . ATHI-2 – 14 ga. galvanized steel. ATHI – 18 ga. galvanized steel. Special . . stocked skewed hangers are designed for standardization and construction economies, and to provide compatibility with the ATHI hanger hardware line. (ATHI 1.81/22 only) Installation . . ATHI-2 hangers are available in widths between 3 and 5¹⁄₄ inches. Specify width at time of order. Triangle Holes Provided for Optional High Uplift Values. table. Verify that the header dimensions will accommodate the specified nails. stiffeners. ATHI, and 30 face nails for ATHI-2 achieves maximum table load. nails listed are used, allowable load must be reduced for each nail eliminated. Angle Nailing to Prevent Wood from Splitting and SuperSpeed® Installation strap must be field bent over top of header a minimum of 2¹⁄₂ inches. 28 www.itwbcghardware.com - 800.521.9790 ITW BCG Hardware

• Cover