Alpine

MTHTF2 MULTIPLE TRUSS HANGER MTHTF2-2 TOP FLANGE Design Features . . The MTHTF hanger is the largest capacity nail-on hanger available. This is a welded hanger designed to carry up to three trusses intersecting at one point into a double-ply girder truss. The top flange is notched at the center to accommodate vertical and diagonal web members in the girder truss. Material . . MTHTF2 – top flange 3 ga. steel, stirrup 11 ga. steel. MTHTF2N – top flange 3 ga. steel, stirrup 11 ga. steel. MTHTF2-2 – top flange 3 ga. steel, stirrup 7 ga. steel. MTHTF2-2N – top flange 3 ga. steel, stirrup 7 ga. steel. Finish . . SUPERSPEED gray paint. Installation . . Distribute the total load evenly about the centerline to avoid an eccentric loading condition. MTHTF2-2 MTHTF2 Top View MTHTF2-2 Similar Top View MTHTF2-N Similar other than the connector, to act as a single unit. MTHTF2 and MTHTF2N, a minimum 2 x 6 vertical member is required. For MTHTF2-2 and MTHTF2-2N, a minimum of 2 x 8 vertical member is required. a 2 x 6. Options . . For larger bottom cord, increase H1 and H 2 accordingly. Maximum skew of hip stirrups is 45 degrees. For MTHTF2, maximum W1 and W2 is 3⁷⁄₁₆ inch. W1 and W2 must be the same. TGH2 (R/L) TRUSS GIRDER HANGERS SKEWED Design Features . . for use with skewed multiple member girder truss conditions., specify right (R) or left (L). Skewed Right Fastener Schedule . . ³⁄₄ MB and 4-l0d nails. Header Material . . 10 gage galvanized steel. Installation . . use all specified fasteners. TGH2 R/L to the vertical carrying member. TGH2R (RIGHT) IS JO centerline to avoid eccentric loading. T Truss Girder Hanger (Skewed) TGH2 (R/L) to allow for the minimum bolt end distance. 2 x 10 bottom cord take 0.62 of the design load. TGH TGHH TGHW TRUSS GIRDER HANGERS TGH2 Design Features . . a hanger designed to carry multiple member girder trusses, (2) 2 x 6, (3) 2 x 6 and (4) 2 x 6. Filler blocks must be used for this application. Material . . ¹⁄₄" steel. TGHH3 Finish . . SUPERSPEED gray paint. Special . . features of the TGH include: the TGH2 or the TGH3 and 2 x 8 for the TGH4. TGH must be bolted to the center of the vertical carrying member. TGHW may be increased with extra nails; however, a filler block must be used. values. act as a single unit. Skewed Hangers . . available, specify angle (50° max) and whether left or right. Due to the infinite variety of custom orders, skewed hangers are not evaluated. Design loads of the nearest equivalent hanger should be used as a general guide, subject to specific engineering designs. Optional SUPERSPEED Drive Screws Used Sc W With This Product 26 www.itwbcghardware.com - 800.521.9790 ITW BCG Hardware

• Cover